Volkswagen Bus, Vanagon, Eurovan Brakes and Brake Parts

VW Bus and VW Westfalia Camper 64-70
Also 1963 with 1500cc Engine

The front wheel cylinders are bolted to the backing plate
inside the front brake drum and connect to the master cylinder
with hydraulic hoses and brake lines.

VW Bus 55-63

The front wheel cylinders are bolted to the backing plate
inside the front brake drum and connect to the master cylinder
with hydraulic hoses and brake lines.

VW Bus and VW Westfalia Camper 55-71 From vin# 20-117902

Rear brake wheel cylinders bolt to the backing plate
inside the rear brake drum and connect to the master
cylinder with hydraulic hoses and brake lines.

VW Bus and VW Westfalia Camper 55-71   From Vin 20-117 902

Rear brake wheel cylinders bolt to the backing plate
inside the rear brake drum and connect to the master
cylinder with hydraulic hoses and brake lines.
 

VW Bus, Westfalia Camper 71-72

VW Vanagon 80-85

VW Bus and VW Westfalia Camper 64-70

VW Bus and VW Westfalia Camper 64-70
VW Bus 1963 with 1500 cc engine

VW Bus and VW Westfalia Camper 1971

VW Bus and VW Westfalia Camper mid73-79   From vin# 2x3 2102 497

VW Bus 1955-67

VW Bus 1968-79

VW Vanagon 80-91

VW Bus 64-70

Note: Uses aftermarket seal: 8941086630

VW Bus 71-79

VW Bus 68-70

VW Beetle and VW Super Beetle 68-79
VW Karmann Ghia 68-74
VW Bus 74-79
VW Type 3 72-73
VW Thing 73-74

These plugs insert into the adjusting holes on the rear of the
brake backing plates and prevent debris from entering
the brake drums or brake shoes.

VW Beetle and VW Super Beetle 50-79
VW Karmann Ghia 56-74
VW Bus 50-70 front
VW Bus 50-79 Rear
VW Type 3 64-73

The brake adjuster nut fits inside the brake drum. It attaches to
the adjusting block on the backing plate and tightens or loosens
the brake shoe.

Adjusting screw for brake shoe.

VW Bus 56-70 Front
VW Bus 56-79 Rear

These are sold individually (4 required per car.)
The screw is attached inside the brake drum. In the front
the screw threads into the nut inside the wheel cylinder.
In the rear the nut is in the adjuster block. Two screws
are required for each brake drum.

Brake and Clutch Pedal Stop 58-79 VWs

Hand Brake Cable Retaining Clamp to Plate
Front or Rear One Bolt Wheel Cylinders
Transmission Mount
 

VW Bus 1955-70

Also goes in emergency brake anchor pin
(Wave Washer for Under Alternator/Generator Nut)

VW Beetle and VW Super Beetle 56-79
VW Karmann Ghia 56-74
VW Bus 56-79
VW Type 3 62-73
VW Thing 73-74

VW Bus 1960-79  Beginning chassis# 614456

VW Beetle and VW Super Beetle 50-79
VW Karmann Ghia 56-74
VW Bus 50-79
VW Type 3 60-79
VW Thing 73-74

VW Bus 73-79
VW Vanagon 86-91
VW Karmann Ghia 73-74   Beginning with vin# 143 2013 627

VW Beetle and VW Super Beetle
VW Bus
VW Karmann Ghia
VW Type 3
VW Thing
VW Vanagon

VW Bus 71-72

VW Bus 68-79  Left (Driver) Side Only
VW Type 3 68-73
VW Type 3 1968 with AutoTrans

VW Super Beetle 1971-79
VW Bus 71-79

VW Beetle 48-64
VW Karman Ghia 56-64
VW Bus 50-54 and 68-70

VW Bus 71-72

VW Bus/Vanagon 86-91

VW Bus 68-71

VW Bus 71-72
VW Karmann Ghia 56-66 master cylinder to rubber hose.

VW Bus mid55-mid67

From vin# 20-117 902 to 2_7 019 487.

VW Bus 55-70

VW Bus 71-79
VW Karmann Ghia 56-74 master cylinder to T connector

All VWs

VW Beetle and VW Super Beetle 50-79 3 required
VW Karmann Ghia 56-74 3 required
VW Bus 50-79 8 required
VW Type 3 62-73 10 required
VW Thing 73-74 3 required

VW Beetle and VW Super Beetle 72-79
VW Karmann Ghia 72-74
VW Vanagon 80-91
VW Thing 73-74
VW Type 3 72-73

VW Bus 73-79

VW Bus 1971-1972

Use with washer N138272

VW Bus 50-67

VW Beetle 54-60
VW Bus, early bus with metal reservoir
VW Karmann Ghia 56-60

VW Bus 64-67

VW Bus 72-79

VW Bus 68-71  Beginning with vin# 218104708

note: cars without brake servo

All VWs

VW Bus 68-79

VW Beetle 46-67
VW Karmann Ghia 56-67
VW Type 3 62-67
VW Bus 50-67

VW Bus 1955-79

VW Beetle and VW Super Beetle 1950-79
VW Bus 1950-79
VW Karmann Ghia 1956-74
VW Type 3 1962-73
VW Thing 1973-74

• 1949-1979 VW Beetle and Super Beetle
• 1956-1974 VW Karmann Ghia
• 1950-1979 VW Bus
• 1973-1974 VW Thing

• 1949-1979 VW Beetle and Super Beetle
• 1971-74 VW Karmann Ghia
• 1950-1979 VW Bus
• 1973-1974 VW Thing

Fits: VW Bus 1955-1963

Fits: 1967 VW Bus

This kit includes: 2 Inner Wheel Bearings and Races (Races preinstalled in rotor); 2 Inner Grease Seals; 2 Outer Wheel Bearings and Races (Races preinstalled in rotor); 2 Wheel Bearing Thrust Washers; 4 Spindle Nuts; 2 Spindle Nut Lock Plates; 2 Left & Right Front Grease Caps; 2 Disc Brake Rotors; 10 M14x1.5 Lug Studs; 2 Left & Right Calipers; 2 Left & Right Caliper Brackets; 8 M10x1.5x25 Caliper Bracket Bolts; 8 3/8" Hardened Flat Washers; 4 M12x1.5x40 Caliper Mounting Bolts; 4 Caliper Bolt Dust Covers with installation tool; 2 355mm Flexible Brake Hoses; 4 Disc Brake Pads with adhesive backing plates; 1 Caliper Hardware Kit; 1 Master Cylinder; 1 Master Cylinder Reservoir; 1 Caliper Bolt Dust Cover Installation Tool; 1 Loctite 430

VW Bus 1971-74 up to ch# 2142110465

VW Bus 1971-79
This valve fits standard 12mm vacuum hose.

VW Beetle 50-69
VW Karmann Ghia 50-69
VW Bus 50-69
VW Vanagon 80-91
VW Type 3 62-69

This is a VW 2 Prong Brake Light Switch. The switch threads into
the master cylinder and operates the brake lights. This is a simple
two way (open/close) switch and is compativle with 6 or 12v systems.
If you have a Vanagon make sure your switch is two prong.

VW Beetle and VW Super Beetle 70-79
VW Karmann Ghia 70-74
VW Type 3 70-73
VW Vanagon 80-91 Vanagons with 3 Prong
VW Thing 73-74
VW Bus 70-79

This is the VW 3 Prong Brake Light Switch. The switch threads into the
master cylinder and operates the brake lights and the dash brake warning light.
The switch is a simple open-close circuit switch: Power in/out of two of the
terminals. The third powers the dash light.
The switch is compatible with 6 or 12 volt systems