VW Beetle & VW Super Beetle 1967-79 VW Bus 1966-68 VW Karmann Ghia 1967-74 VW Thing 1973-74
VW Beetle 1971-74 VW Bus 1960-71 VW Thing 1973-74 VW Karmann Ghia 1961-74
Pull Motor & Replace: Clutch, Release Bearing, Crank Seal, Rear Mounts & Clutch Cable
Tear Down, Clean Up, Inspection & Assembly.
These are carefully stamped to fit, without common gaps, at the end of the fan shroud.
For all 1300-1600cc VW engines with heater boxes. Directs the air coming from between the heads and cylinders towards the back of engine.
1966-1979 VW Beetle & VW Super Beetle 1960-71 VW Bus 1973-1974 VW Thing 1960-74 Karmann Ghia Note: These plates are usually missing. They should be installed for best engine cooling. Fits under cylinder heads to deflect heat. Will fit 66-67 models but do not have the original hose holes.
Installed between push rod tubes and cylinders air is forced directly to the cylinder enabling best running temperature.
VW Beetle & VW Super Beetle 1965-79 VW Karmann Ghia 1965-74 VW Bus 1963-71 VW Thing 1973-74 This is the heat deflector on the front right side of the engine. The bottom piece is sold separately. Highly recommended to cool your engine temp. Note that there are three pieces required.
VW Beetle & VW Super Beetle 1965-79 VW Bus 1963-71 VW Karmann Ghia 1965-1974 VW Thing 1973-74 This is the heat deflector on the front left side of the engine. The bottom piece is sold separately. Highly recommended to cool your engine temp. Note that there are three pieces required.
VW Beetle & VW Super Beetle 1965-79 VW Bus 1963-71 VW Karmann Ghia 1965-74 VW Thing 1973-74
VW Beetle & VW Super Beetle 1966-79 VW Karmann Ghia 1966-74 VW Bus 1963-71 VW Thing 1973-74 The cylinder defector tin goes between two cylinders. Directs air in between the cylinder cooling fins. Installed above the pushrod tubes and must be installed before the push rod tubes. Sold each.
VW Beetle & VW Super Beetle 1966-79 VW Bus 1963-71 VW Karmann Ghia 1973-74 VW Thing 1973-74 The cylinder defector tin goes between two cylinders. Directs air in between the cylinder cooling fins. Installed above the pushrod tubes and must be installed before the push rod tubes.Sold Each.
VW Beetle & VW Super Beetle 1966-79 VW Karmann Ghia 1963-74 VW Bus 1963-71 Forces air directly at cylinder enabling best running temperatures.
Fits original small style pulley tin. Does not have intake manifold heat riser cutouts. With original intake manifold with heat riser pipes
For 1600 cc engines.
VW Beetle & VW Super Beetle 1971-79 VW Bus 1971 VW Karmann Ghia 1971074 VW Thing 1973-74 Directs hot air out of your engine compartment.
VW Beetle and VW Super Beetle 56-79 VW Karmann Ghia 56-74 VW Bus 56-71 VW Thing 73-74
VW Beetle 1971-79 VW Bus 1971 VW Karmann Ghia 1971-74 VW Thing 1973-74
This doghouse-style fan shroud replaced the upright version for cars after 1971. This newer design was more effective in treating bigger 1600cc engines. The fan pulls in air while the shroud creates a channeling effect to disperse it towards the Oil Cooler.
This plate is located behind the lower crank pulley
VW Beetle & VW Super Beetle 1961-79 VW Karmann Ghia 1961-74 VW Bus 1961-71
Selling classic Volkswagen parts since 1975
Copyright © 2024 M&T Manufacturing