Also: Boot for Emergency Brake Cable at Chassis for Bus
Clutch Boot For: VW Beetle and VW Super Beetle 50-79 VW Karmann Ghia 56-74 VW Bus 50-79 Two required VW Thing 73-74 VW Type 3 62-67
Emergency Brake Cable For: VW Bus 60-79 From vin#614456 The clutch cable boot holds and seals the guide tube for the clutch and accelerator cables. Increases the life expectancy of the cables. Similar function for brake cable.
VW Beetle and VW Super Beetle 1961-79 VW Karmann Ghia 1961-74 VW Thing 1973-74 VW Type 3 1961-74
VW Beetle 50-65 VW Karmann Ghia 56-65 This seal installs behing the tunnel inspection plate at the chassis framehead. prevents debris from entering the inspection tunnel.
VW Beetle and VW Super Beetle 67-79 VW Karmann Ghia 67-74 VW Type 3 67-73 VW Thing 73-74 This valve installs under the main conduit, draining out moisture while preventing moisture from getting in toward the floor pan.
These tubes encase the heater cable.
VW Beetle and VW Super Beetle 68-79 VW Karmann Ghia 68-74 VW Bus 50-67 VW Type 3 68-72 VW Thing 73-74
VW Beetle (Standards)66-77 VW Karmann Ghia 66-74 VW Thing 73-74
VW Beetle and VW Super Beetle 50-79 VW Karmann Ghia 56-74 VW Type 3 62-73 VW Thing 73-74
VW Beetle 62-65 VW Karmann Ghia 62-65 VW Type 3 62-65 VW Thing 73-74
Use with mount 311-301-265A
VW Beetle 50-59 VW Karmann Ghia 56-59 These install into the rear torsion housing on the sides of the spring plate. They hold the plate in the torsion housing; one on left, one on right side of car and the other two inside the spring plate cap. (The cap is bolted over the spring plate/torsion housing.)
VW Beetle 1960-68 VW Karmann Ghia 1960-68 VW Type 3 61-68 These install into the rear torsion housing on the sides of the spring plate. They hold the plate in the torsion housing; one on left, one on right side of car and the other two inside the spring plate cap. (The cap is bolted over the spring plate/torsion housing.)
VW Beetle and VW Super Beetle 1969-79 VW Karmann Ghia 1969-74 VW Thing 1973-74 These install into the rear torsion housing on the sides of the spring plate. They hold the plate in the torsion housing; one on left, one on right side of car and the other two inside the spring plate cap. (The cap is bolted over the spring plate/torsion housing.)
Brake and Clutch Pedal Stop 58-79 VWs Hand Brake Cable Retaining Clamp to Plate Front or Rear One Bolt Wheel Cylinders Transmission Mount
VW Beetle and VW Super Beetle 69-79 VW Karmann Ghia 69-74 VW Type 3 68-73 VW Thing 73-74
Front Axle Beam Mounting Bolt for following: VW Standard Beetle 1946-1977 VW Karmann Ghia 1956-1974 VW Thing 1973-1974
Shock Absorber Mounting Bolt for following: VW Beetle 10/52-5/59 (upper and lower) VW Karmann Ghia 1956-5/59 (upper and lower) VW Bus 1950-1967 (lower only)
VW Beetle and VW Super Beetle 1956-79 VW Karmann Ghia 56-74 VW Type 3 all VW Thing 1973-74 These pads sit between the body and chassis and help absorb road vibration
VW Beetle (Standards) 50-77 VW Karmann Ghia 56-74 VW Thing 73-74 Install between the body and the front axle beam to prevent vibration
VW Beetle and VW Super Beetle 46-79
VW Beetle and VW Super Beetle 60-79
VW Beetle and VW Super Beetle 50-79 VW Karmann Ghia 56-74 VW Thing 73-74
VW Beetle (Standard) 1966-78 VW Karmann Ghia 1966-74
VW Beetle Convertible 1966-70 VW Beetle Sedan 1966-77 VW Karmann Ghia 1966-74
Recommended for all models.
VW Beetle 58-71 VW Super Beetle 1971 VW Karmann Ghia 58-71 VW Thing 73-74 VW Type 3 61-74
1958 Beetles and Ghias beginning vin# 1862188 1971 Beetles and Ghias up to vin# 1_1 2317004
VW Beetle and VW Super Beetle 60-79 VW Karmann Ghia 60-74 VW Type 3 62-73 Prevent suspension from bottoming out.
VW Beetle Sedans 1959-77
Repair, Replacement, Remove Body & Basic Welding
VW Beetle 53-74 VW Super Beetle 71-79 VW Karmann Ghia 56-74 VW Thing 73-74 VW Type 3 62-73 These fuel line grommets install at the chassis front under the fuel tank and also at the rear along the transmission.
also fits 1968 with autostick
Selling classic Volkswagen parts since 1975
Copyright © 2024 M&T Manufacturing